Multiplaz 3500 Specifications download pdf (Page 21)

Caution

When operating in MODE I or

- Remove any molten splatter accumulated on nozzle by touching nozzle lightly with file

or metal brush

MODE II

- If the jet should become extinguished inadvertently, fully press and immediately but

slowly release the torch start button within 5 seconds as for a nominal start to re-

establish jet

When torch runs out of water, jet becomes elongated (or extinguished) and voltage

reading drops If this were to happen, shut torch down manually before it shuts down

automatically from overheating

- If torch runs dry, it shuts down automatically, and OVERHEAT LED of is

illuminated To proceed with operation, perform steps in Section and restart torch

Do not leave operating torch unattended

- Do not allow unprotected areas of your body to come into contact with hot torch

surfaces

When operating in MODE II do not allow conductive items to come into contact with

nozzle or cap unless secured in filler holder

- Do not remove filling neck cap while torch is operational

. 4.8 .

power supply

Caution!

- (see

7.1 , 7.1 ).

Shut down and cool torch if nozzle turns red or jet turns green for a long time

Sections 1 2

4.7 Torch shutdown

- Press power supply

- Verify that power supply “OFF” LED is illuminated.

- Cool torch by dipping nozzle in 3-5 cm (1-2 inches)

of WATER for a several seconds until sizzling

sound stops or keep it dipped for 2-3 minutes to

fill the torch automatically (see 4.8.2).

”OFF” button on (see Figure)

Caution

If you want to shut torch off in case of emergency,

press and hold start button 6-8 seconds.

5.9

Refilling Torch

Caution

To refill torch with water/ethanol mixture, perform the steps described in Section 5.8 and

5.2

Automatic torch refilling Section with water/ethanol mixture is not possible

Cool in WATER ONLY. Cooling in water/ethanol mixture could cause a fire

Press ”OFF” button on

Be sure that OFF LED is illuminated

torch cable connector from power supply outlet connector to select cutting

mode proceed to Section

filler holder from power supply

- Disconnect power supply power cable from wall receptacle

- Disconnect MODE II wire with clamp from power supply

Perform system maintenance in a timely manner

Power supply maintenance requires blowing of vents and fan screens on a regular

basis

Torch maintenance requires regular inspections, timely cleaning of torch components,

and replacement as necessary

It is prohibited

to perform maintenance with torch operational and with torch cable connected to power

supply

( 4.8.2) .

- .

-”” .

4.2).

5.10 After Operation

power supply

Disconnect

6. ystem Maintenance Torch Assembly and DisassemblyS. .

1 2 ... 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

Multiplaz 3500 Specifications Page 21

Comments to this Manuals

Related products and manuals for Welding System Multiplaz 3500